Our Floor Sealer provides optimum all-round protection for porous building materials. This single product
provides water and oil repellent protection for floors.
Our Floor Sealer can be used inside and outdoors on both highly porous and low porosity materials eg. limestone,
granite, sandstone, marble, slate, quarry tiles and surfaces subject to high levels of foot traffic including pavements,
pedestrian precincts, patios, swimming pool decks, stairways and car parking area
Our Floor Sealer is a non-film-forming surface impregnation, where the surface remains permeable to air and
Our natural stone and terracotta sealer does not alter the surface colour. Aesthetics and composition of the treated material remain
unchanged. A surface becomes UV-resistant and will not discolour with age.
A surface treated with our Floor Sealer will wear better over time and be easier to maintain. This treatment also
offers a solution to the main causes of deterioration, like atmospheric pollution, grease-type dirt, penetration of
liquids, graffiti and also makes chewing-gum easier to remove.
Water-based fluoropolymer dispersion.
Advantages & Characteristics
Effective for 12 years, on vertical surfaces
Can be applied to vertical, horizontal, inside & outside surfaces
Prevents the penetration of water & oily liquids
Limits efflorescence formation
By keeping the fabric of a surface dry gives resistance to moss and lichen growth.
Anti-staining, anti-dirt. Prevents chewing-gum from sticking to treated surfaces and stops dirt due to
pollution from building up again.
Prevents deterioration resulting from repeated ‘freeze-thaw’ cycles
Treated surfaces become easier to clean
Non film-forming, allowing a surface to breathe
Non-flammable; Non-hazardous & Non-toxic
Water-borne; Solvent and silicone-free
>95% biodegradable according to OECD standards
UV-resistant, does not discolour. Invisible once dry
Chemically resistant to mild acids and alkalis and de-icing salts.
Ready to use; Easy to apply.
Shake the container well before use
Ensure the surface to be treated is clean, dust-free and visually dry before application.
The surface moisture content needs to be a <5% up to a depth of 1cm.
Use neat; do not dilute
Apply using a low-pressure sprayer, roller or brush
The treated surface has to be applied to saturation, either in one application or in two applications ‘wet-onwet’
On vertical surfaces, apply from the bottom up taking care of avoiding the product to ‘run’.